1 847 623-7029
Even though this Support Stand was engineered for the EZ Speedy Fence this Support Stand stands on its own.
This stand has one adjustment point at the top.
A hole with 1/2-13 inch thread pitch is on the top face of the hex mount for easy attachments to anything.
The hex mount slides right off when you loosen the 1/2-13 inch bolt on the side or upgrade to the T-Knob for $6. Tighten it up to maintain rigidness.
Height Range is 32-1/4" to 39-1/2"
This stand has claw feet at its base to handle rough surfaces easily.
Average Lead Time 1 week
DeWalt DW716, DHS716, DW716XPS EZ Speedy Zero Clearance Fence
1 847 623-7029
Lead Time 1 week
Exact fit for the DeWalt Model # DW716, DHS716, DW716XPS
If you are looking to increase the safety and precision of your cuts then our Zero Clearance Fence is the perfect product for you. No more small pieces jamming into your standard fence and binding your blade.
- Increase product cutting support.
- Reduce chipping
- Reduce kickback
- Reduced blade binding cutting small parts.
We also put a relief cut on the inside edges of the aluminum fence. This will allow you to change the angle of your saw while still being able to accurately hook your tape measure onto the fence edge. Enabling you to setup a miter cut as quickly and accurately as a 90-degree cut.
The two aluminum fence pieces come shipped with flat head bolts + flange nuts.
For greater accuracy, efficiency and safety, we recommend pairing our Zero Clearance Fence with our Zero Clearance Table Insert.